Skip to content
MSdean
Contact Us
Manufacturing example

Aluminum housing with leak testing

An ADC12 housing route that connects edge preparation, surface finishing and CNC machining with dedicated leak-test fixturing.

Material
ADC12 aluminum
Inspection
Part-by-part leak check
Scope
Process & inspection
Aluminum housing process model with locating features marked

The complete route matters to the test

Casting features

Review filling and locating features before subsequent operations.

Delivered interfaces

Plan the coating and machining sequence around the required finished features.

Test setup

Confirm the fixture, reference pieces and acceptance criteria for the housing.

A route from casting to final inspection

This manufacturing example follows the supplied housing instruction. Test limits and process settings are set for the project.

  1. Casting and gate removal

    Check casting appearance and remove the defined runner and overflow material.

  2. Edge preparation

    Prepare gate and parting-line areas while maintaining the intended edges and form.

  3. Surface preparation and cleaning

    Remove residue and follow the cleaning sequence before the coating operation.

  4. Coating

    Protect specified features and inspect the finished appearance against the agreed reference.

  5. CNC machining

    Locate the housing in dedicated fixtures and verify the required machined features.

  6. Leak check and packing

    Test each part under the agreed conditions, identify nonconforming parts and pack accepted housings.

Plan the locating and machined features

  1. Support the part in the fixture

    Seat and clamp the housing in the defined position without damaging the surfaces.

  2. Check openings and threads

    Inspect the machined areas and use the specified dimensional or thread-checking method.

  3. Review the condition after finishing

    Confirm the coating, machining sequence and test interfaces together for the final part condition.

Dedicated fixture process model for machining the housing

Prepare the surface without losing the features

Housing process view identifying gate and edge preparation areas

Defined edge areas

Follow the marked preparation areas and protect the intended corners.

Cleaning tanks shown in the housing work instruction

Cleaning before coating

Remove residue and keep parts separated during the cleaning and drying handover.

Housing coating process model identifying surfaces and masking features

Coating and masking

Define the surfaces to coat and the features that require protection.

Leak-test controls for every housing

A dedicated fixture supports the part while the test follows the method and limits agreed for the project.

  1. Verify the test setup

    Use known acceptable and unacceptable test pieces to check the instrument response before releasing the setup for production.

  2. Seat and clamp correctly

    Confirm that the housing is positioned correctly in the fixture. Avoid clamping damage and an incorrect setup.

  3. Run the agreed test

    Inspect each housing using the confirmed fixture and test conditions. Record the result in the agreed format where required.

  4. Identify and separate exceptions

    Mark nonconforming parts and place them in the defined holding area for review.

Dedicated leak-test fixture shown in the housing work instruction

Project-specific limits: agree the test method, pressure, duration and acceptance criterion for the actual part and fixture.

Protect accepted housings for handover

  1. Accepted parts only

    Complete the required appearance, dimensional and leak-test checks before packing.

  2. Individual formed locations

    Use the specified tray and protective materials to limit contact between parts.

  3. Quantity and identification

    Confirm the contents, separators and label information against the packing specification.

Aluminum housings separated in a formed protective tray

Agree the inspection requirements early

RequirementInformation for the project review
Critical interfacesIdentify the drawing features, finish and mating conditions that affect the test setup.
Leak testDefine the test method, limits and reference-piece requirements.
EvidenceSpecify the inspection records and report format you need at quotation.
ProtectionConfirm the tray, protective materials and packing quantity.

Review a housing with leak-test requirements

Send the drawing, finished condition and test requirement so we can review the manufacturing and inspection route together.

Get in touch

Discuss your project

Share your part drawing, material and expected quantity.

Portfolio preview. This form is for demonstration only.

The details you provide will be used to respond to your project inquiry.