Casting features
Review filling and locating features before subsequent operations.
An ADC12 housing route that connects edge preparation, surface finishing and CNC machining with dedicated leak-test fixturing.

Review filling and locating features before subsequent operations.
Plan the coating and machining sequence around the required finished features.
Confirm the fixture, reference pieces and acceptance criteria for the housing.
This manufacturing example follows the supplied housing instruction. Test limits and process settings are set for the project.
Check casting appearance and remove the defined runner and overflow material.
Prepare gate and parting-line areas while maintaining the intended edges and form.
Remove residue and follow the cleaning sequence before the coating operation.
Protect specified features and inspect the finished appearance against the agreed reference.
Locate the housing in dedicated fixtures and verify the required machined features.
Test each part under the agreed conditions, identify nonconforming parts and pack accepted housings.
Seat and clamp the housing in the defined position without damaging the surfaces.
Inspect the machined areas and use the specified dimensional or thread-checking method.
Confirm the coating, machining sequence and test interfaces together for the final part condition.


Follow the marked preparation areas and protect the intended corners.

Remove residue and keep parts separated during the cleaning and drying handover.

Define the surfaces to coat and the features that require protection.
A dedicated fixture supports the part while the test follows the method and limits agreed for the project.
Use known acceptable and unacceptable test pieces to check the instrument response before releasing the setup for production.
Confirm that the housing is positioned correctly in the fixture. Avoid clamping damage and an incorrect setup.
Inspect each housing using the confirmed fixture and test conditions. Record the result in the agreed format where required.
Mark nonconforming parts and place them in the defined holding area for review.

Project-specific limits: agree the test method, pressure, duration and acceptance criterion for the actual part and fixture.
Complete the required appearance, dimensional and leak-test checks before packing.
Use the specified tray and protective materials to limit contact between parts.
Confirm the contents, separators and label information against the packing specification.

| Requirement | Information for the project review |
|---|---|
| Critical interfaces | Identify the drawing features, finish and mating conditions that affect the test setup. |
| Leak test | Define the test method, limits and reference-piece requirements. |
| Evidence | Specify the inspection records and report format you need at quotation. |
| Protection | Confirm the tray, protective materials and packing quantity. |
Send the drawing, finished condition and test requirement so we can review the manufacturing and inspection route together.